Log Entry 18th June 2017

Most of the day has been spent preparing the patch material, the plan being to have a go at vacuum pressing that to achieve a thinner and stronger patch.

Shown below is a close-up of the bevel edge on the corner pads and holes which have been filled with epoxy filler.  The final hole will be smaller, and thus the hole will be surrounded by epoxy, so if there is a leak it will not have an easy path to the plywood.

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *

CAPTCHA
Reload the CAPTCHA codeSpeak the CAPTCHA code